Output signals measured with a Memory HiCorder to simulate anomalous events for scenario testing
The Arbitrary Waveform Generator Unit U8793 is a plug-and-play module for the Hioki Memory HiCorder to create a function generator, arbitrary waveform generator, and waveform measurement in a single device. Easily observe waveforms while varying test conditions, such as changing the signal's amplitude and frequency as well as programming various waveforms to output in order.
After you install the included SF8000 Waveform Maker software on your computer, you can create waveforms easily by either entering them directly or by entering the formulas behind them. You can also quickly add noise and multiply waveforms.
Reproduce and output the observed waveforms without modification. When resolving problems observed during research or development, you can reproduce such problems for efficient testing. For example, you could output actual waveforms recorded from a car without modification, and then use them for standalone testing. You can also generate isolated output of up to 15 V while varying the signal’s amplitude and frequency without using a generator or amplifier, which is traditionally necessary. For example, you can create a power waveform such as power supply dips, instantaneous interruptions, and voltage fluctuations to use in an immunity test (to cause malfunctions in equipment caused by power supply harmonics).
| Output terminal | Number of channels: 2, SMB terminal (Output impedance: 1 Ω or less) Max. rated voltage to ground: 30 V rms AC or 60 V DC |
|||||
|---|---|---|---|---|---|---|
| Output voltage range | -10 V to 15 V (Amplitude setting range: 0 V to 20 V p-p, Setting resolution: 1 mV) | |||||
| Max. output current | 10 mA (Allowable load resistance: 1.5 kΩ or more) | |||||
| Function generator | DC, Sine wave, Square wave, Pulse wave, Triangular wave, Ramp wave, Output frequency: 0 Hz to 100 kHz | |||||
| Arbitrary waveform generator mode | Waveforms measured by MR8847A, etc., generated by Hioki Model 7075, PQ3198, or SF8000, CSV waveforms D/A refresh rate: 2 MHz (using 16-bit D/A) |
|||||
| Sweep function | Frequency, Amplitude, Offset, Duty (Pulse only) | |||||
| Program function | Max. 128 steps (Number of loops for each step, Number of total loops) | |||||
| Other | Self-test function (Voltage), External input/output control | |||||
| Dimensions and mass | 106 mm (4.17 in) W × 19.8 mm (0.78 in) H × 196.5 mm (7.74 in) D, 250 g (8.8 oz) | |||||
| Included accessories | None | |||||
